diagram fo a doorbell camera and non power chime

#Diagram fo a doorbell camera and non power chime how to#

16V chime should be wired to a 16V transformer) You'll want to ensure that the voltage coming from the transformer matches the voltage of the chime kit (e.g. It’s important that you don’t over-tighten those screws they should be flush with the unit. Place the Ring Doorbell on the bracket and then use the included Ring screwdriver to tighten each of the screws on the underside of the device. Take your doorbell wires and loop them around the terminals, then tighten each of the screws, securing the wires to the mounting bracket. Once the mounting bracket is screwed in, remove the level and make sure the terminal screws are slightly backed out.Ħ. Place the mounting bracket and included level against the wall and mark off holes where you'll need to screw.ĥ. We recommend using caulking (not included) to plug the hole left from the doorbell wiring.Ĥ. Remove your doorbell and then remove the screws that are attached to the actual wires.ģ. Turn off any power to your preexisting doorbell.Ģ.

#Diagram fo a doorbell camera and non power chime how to#

How to replace your existing doorbell with Ring Video Doorbell.ġ. If you have a doorbell like this, do NOT use a diode.Ĭlick below to view this demonstration video on our official YouTube channel: You can see physical strikers that move to hit plates which give the tone. This picture shows a mechanical chime without the cover.

The connection will also trickle charge your Video Doorbell and should prevent you from needing to recharge the battery. Once hardwired, you should see the LED lights on the front of your Video Doorbell illuminate with a soft white light.

Ring Video Doorbell is compatible with many different types of mechanical door chimes as long as they're between 8VAC-24VAC.